Prashnikaप्रश्निका
Code
About
PhysicsClass 12

Junction transistor - ISC Class 12 Physics Questions with Answers

2 past-paper questions on Junction transistor from ISC Class 12 Physics papers (2020-2018), newest first, in full. Tap "Show answer" under a question to see its answer. The syllabus covers npn and pnp transistor, Transistor action and characteristics and Transistor as an amplifier.

2questions
2years
2020newest
20201 question
5 marks · DrawingOpen: Draw a labelled circuit diagram of a transistor acting as a common emitter…

Draw the following.

(i)[3]
Draw a labelled circuit diagram of a transistor acting as a common emitter amplifier. What is meant by phase reversal?

Draw: Circuit diagram of an npn or pnp transistor acting as a common emitter amplifier

Must show: Common emitter configuration with emitter grounded, Base-emitter forward biased with input signal, Collector-emitter reverse biased with output across load, Input AC signal and inverted 180 degree out-of-phase output signal

(ii)[2]
Draw the symbol of a NAND gate and write its truth table.

Draw: Logic symbol of a 2-input NAND gate

Must show: AND gate shape with inversion bubble at output, Two input lines labelled A and B, Output line labelled Y

Show answer

Answer (i)

Common emitter amplifier using an npn transistor: emitter connected to ground (common to input and output); the base-emitter junction is forward biased by $V_{BB}$ through $R_B$, with the ac input signal $V_i$ applied between base and emitter through a capacitor; the collector is connected to $V_{CC}$ through the load $R_L$ (collector-emitter reverse biased) and the amplified output $V_o$ is taken between collector and emitter through a capacitor. Phase reversal: the output voltage is $180^\circ$ out of phase with the input voltage (when the input rises, the output falls and vice versa).

Answer (ii)

NAND gate symbol: an AND gate shape with a small circle (bubble) at the output, inputs $A$ and $B$, output $Y=\overline{A\cdot B}$. Truth table:
ABY
001
011
101
110
Diagram for this answer
20181 question
5 marks · DrawingOpen: For a transistor in a common emitter mode, draw labelled graph to show: (1)…

Answer the following.

(i)[2.5]
For a transistor in a common emitter mode, draw labelled graph to show: (1) Input characteristic curve. (2) Output characteristic curve. (3) Transfer characteristic curve. (Circuit diagram of the arrangement is not required.)
Figure for part (i)
(ii)[2.5]
The characteristic curve of a silicon diode is shown in Figure 5 below: Calculate the resistance of the diode at: (1) $I = 15\text{ mA}$ and (2) $V = -10\text{ V}$
Show answer

Answer (i)

For a common emitter transistor (n-p-n): (1) Input characteristic: $I_B$ (in $\mu$A) on the y-axis against $V_{BE}$ (in V) on the x-axis, at constant $V_{CE}$; the curve is like a forward diode curve, with $I_B$ rising steeply after the threshold (knee) voltage. (2) Output characteristic: $I_C$ (mA) on the y-axis against $V_{CE}$ (V) on the x-axis, for different fixed $I_B$; each curve rises steeply at small $V_{CE}$ and then becomes nearly flat (active region), curves for larger $I_B$ lying higher. (3) Transfer characteristic: $I_C$ (mA) against $I_B$ ($\mu$A) at constant $V_{CE}$; a nearly straight line through the origin in the active region, then flattening at saturation, with slope $\beta_{dc}$.

Answer (ii)

(1) At $I = 15\text{ mA}$ the diode is forward biased and the curve is steep, so the (dynamic) resistance is the slope: between $I = 10\text{ mA}$ ($V = 0.7\text{ V}$) and $I = 20\text{ mA}$ ($V = 0.8\text{ V}$), $r = \frac{\Delta V}{\Delta I} = \frac{0.8 - 0.7}{(20-10)\times10^{-3}} = 10\ \Omega$. (2) At $V = -10\text{ V}$ the diode is reverse biased with $I = 1\ \mu\text{A}$ (read from the graph), so $R = \frac{V}{I} = \frac{10}{1\times10^{-6}} = 1\times10^{7}\ \Omega$.

Final answer: 10 ohm

About Junction transistor

Junction transistor was a chapter of the Electronic Devices unit of the ISC Class 12 Physics syllabus. It is no longer in the 2027 syllabus: it was last in the syllabus for the 2021 exam, so these questions are for revision only if your course still has it.

The syllabus listed these topics: npn and pnp transistor, Transistor action and characteristics and Transistor as an amplifier.

Prashnika has 2 past-paper questions on Junction transistor, from papers of 2018-2020, asked in 2 different years. By kind: Drawing (2). They carry between 5 and 5 marks, and most are worth 5 marks.

To practise, use the paper generator, which can build a practice paper from this chapter.

Common questions

What topics are in Junction transistor in ISC Class 12 Physics?

The syllabus listed npn and pnp transistor, Transistor action and characteristics and Transistor as an amplifier.

How many questions on Junction transistor are in ISC Class 12 Physics past papers?

Prashnika has 2 questions on Junction transistor, from papers of 2018-2020 (board, specimen, improvement and practice papers together).

What kinds of questions are asked on Junction transistor?

By kind: Drawing (2).