Digital electronics - ISC Class 12 Physics Questions with Answers
2 past-paper questions on Digital electronics from ISC Class 12 Physics papers (2018), newest first, in full. Tap "Show answer" under a question to see its answer. The syllabus covers Analogue and digital signals, Logic gates and Combination of gates.
The arrangement given below represents a logic gate:
Copy the following truth table in your answer booklet and complete it showing outputs at C and D.
A
B
C
D
0
0
1
0
0
1
1
1
(ii)[2]
Draw a labelled diagram of a common emitter amplifier, showing waveforms of signal voltage and output voltage.
Draw: labelled diagram of a common emitter amplifier, showing waveforms of signal voltage and output voltage
Must show: transistor in common emitter configuration, input signal voltage waveform, output voltage waveform with 180° phase change, biasing voltages
Show answer
Answer (i)
A
B
(A.B)'
A.B
0
0
1
0
1
0
1
0
0
1
1
0
1
1
0
1
C = (A.B)' is the output of the first NAND gate; the second NAND gate has its inputs joined, so it acts as a NOT gate and D = C' = A.B. The arrangement acts as an AND gate (output D).
Answer (ii)
A labelled n-p-n transistor in common-emitter configuration: emitter connected to the common (earth) line, input signal $V_i$ applied between base and emitter through a coupling capacitor, and output $V_o$ taken between collector and emitter through a coupling capacitor, with load resistance $R_L$ in the collector circuit. Base bias battery $V_{BB}$ (with $R_B$) and collector battery $V_{CC}$ are shown. Waveforms: a sinusoidal input signal voltage and an amplified sinusoidal output voltage in opposite phase (phase difference $180^\circ$).
Show how you will obtain an AND gate using only NOR gates. Draw the truth table for this arrangement of gates.
(ii)[2.5]
For a common emitter transistor amplifier, the audio signal voltage across the collector resistance ($r_c$) of $2\text{ k}\Omega$ is $2\text{ V}$. If the current amplification factor ($\beta$) of the transistor is $100$, calculate the input signal voltage ($V_{BE}$) and base current ($I_B$) for base resistance of $1\text{ k}\Omega$.
Show answer
Answer (i)
Connect the two inputs of one NOR gate together to get $A'$ (a NOR gate with joined inputs is a NOT gate); do the same for $B'$ with a second NOR gate. Feed $A'$ and $B'$ to a third NOR gate: $Y = \overline{A' + B'} = A\cdot B$, which is the AND operation.
A
B
A'
B'
Y = (A'+B')'
0
0
1
1
0
0
1
1
0
0
1
0
0
1
0
1
1
0
0
1
Answer (ii)
Formulas used: Transistor currents and gains: Ie = Ib + Ic with Ic = 1 mA, beta = 100.0, so Ib = 10 uA
Ohm's law: V = I*R with I = 10 uA, R = 1 kohm, so V = 0.01 V
Digital electronics was a chapter of the Electronic Devices unit of the ISC Class 12 Physics syllabus. It is no longer in the 2027 syllabus: it was last in the syllabus for the 2021 exam, so these questions are for revision only if your course still has it.
The syllabus listed these topics: Analogue and digital signals, Logic gates and Combination of gates.
Prashnika has 2 past-paper questions on Digital electronics, from papers of 2018. By kind: Truth table (1) and Short answer (1). They carry between 5 and 5 marks, and most are worth 5 marks.
To practise, use the paper generator, which can build a practice paper from this chapter.
Common questions
What topics are in Digital electronics in ISC Class 12 Physics?
The syllabus listed Analogue and digital signals, Logic gates and Combination of gates.
How many questions on Digital electronics are in ISC Class 12 Physics past papers?
Prashnika has 2 questions on Digital electronics, from papers of 2018 (board, specimen, improvement and practice papers together).
What kinds of questions are asked on Digital electronics?